Tutorial: Quick “Hi” Card using You Move Me Bundle

“HI THERE” You Move Me Card

1. Fold 8 1/2″ x 5 1/2″ piece of Early Espresso card stock in half to create card base. Use Bone Folder to get a good crisp crease along the fold. 
2. Lightly mist 4 1/4″ x 3″ Whisper White layer with water and place inside “Layered Leaves” 3D Dynamic Textured Impressions Embossing Folder. Run through Big Shot. Set aside to dry. 
3. Once cardstock is dry, add a light wash of colour to the leaves using Pear Pizzazz ink pad and aqua painter.
4. Cut a piece of Wood Textures DSP to measure 1 1/4″ x 4 1/4″ and create edge using Decorative Border punch. Glue behind Whisper White layer.
5. Wrap Berry Bliss ribbon to cover seam between whisper white card stock and the wood texture DSP border. Secure with glue and the add to card base with Stampin’ Dimensionals.
6. On scrap piece of Whisper White, stamp four sets of leaves from “You Move Me”, using Versamark ink. Sprinkle with Gold Embossing power, shake off excess and set with heat tool. Squeeze Pear Pizzazz ink pad to get a puddle of ink on the inside of lid – open and use with Aqua Painter to add a wash of colour inside the gold embossed leaves. Place coordinating leaf thinlet dies over leaves and run through Big Shot with the Magnetic Platform. Use glue dots and dimensionals to add to card, as shown (cutting some of the leaves to use individually).
7. Stamp “Hi there” images from “You Move Me” stamp set using Early
   Espresso ink onto strip of Wood Textures DSP. Colour inside the “hi”
   letters using the white watercolour pencil crayon. Use paper snips to
   create ‘banner’ and glue over the leaves.
8. Ink large flower stamp from “You Move Me” with Berry Burst ink pad and stamp twice onto scrap piece of Whisper White, without re-inking the second time. Cut with coordinating thinlet. Use a sponge to add more Berry Burst ink along the edge of lighter flower. Glue darker flower directly onto the leaves/banner and use a stampin’ dimensionals to add second flower on top.
9. Cut staymen with coordinating thinlet using scrap piece of gold glimmer card stock – use glue dot to add to centre of flower. 
10. Stamp bold image butterfly from “You Move Me” with versamark ink onto a piece of Berry Burst Fresh Floral DSP. Cover with Fold Embossing Powder, shake of excess and set with heat tool. Cut butterfly using coordinating thinlet. Use bone folder along each wing to curl slightly. Colour antenna with Early Espresso ink and gently lift up using bone folder (or paper snips). Adhere to card.
11. To create butterfly body: cut a piece of wood textures DSP into a narrow triangle strip. Place a glue dot on paper piecing tool to hold wide end of DSP strip and start rolling tightly. Use another glue dot to secure end and gently pull off the tool. Use Liquid Glue to adhere to butterfuly, holding for a moment, until glue sets a but.
12. Cut computer paper (or whisper white card stock) to measure 4″ x 5 1/4″ and glue inside the card for message.